Page 3
To obtain service during the warranty period, return the product with proof of purchase to an authorized Amprobe Test Tools Service Center or to an Amprobe dealer or distributor. See Repair Section for details. THIS WARRANTY IS YOUR ONLY REMEDY.
Page 4
Non-Warranty Repairs and Replacement – US and Canada Non-warranty repairs in the United States and Canada should be sent to a Amprobe® Test Tools Service Center. Call Amprobe® Test Tools or inquire at your point of purchase for current repair and replacement rates.
Page 5
MT-10 Moisture Meter Test Probes Cover Display (LCD) Function Button / Power on /off Battery Cover...
Page 6
LCD Display Batteries are low and should be replaced. Wood moisture measurement mode is selected. In this mode, you can measure the moisture level of sawn timber, paper or cardboard. Material moisture measurement mode is selected. In this mode, you can measure the moisture level of hardened material (mortar concrete or plaster).
Don’t use the instrument in the case of inspections or for reference purposes. UNPACKING AND INSPECTION Your shipping carton should include: MT-10 moisture meter 9 volt battery Users manual If any of the items are damaged or missing, return the complete package to the place of purchase for an exchange.
INTRODUCTION Moisture meters MT-10 can be used to measure the amount of water in the wood or building material so that the woodworker can determine if it is suitable for the intended purpose. Building inspectors, carpenters, hobbyists, and other woodworkers often are required to have moisture meters.
Page 10
3. Performing Measurement a) For temperature measurements, the display shows the present environment temperature directly. b) To perform moisture measurements, drive the probes into the wood or material to be measured, read the reading on the display. 4. Automatic Power-Off Feature a) In wood moisture or material moisture measurement mode, if you don’t operate the instrument (or the reading does not change)
MAINTENANCE AND REPAIR If there appears to be a malfunction during the operation of the meter, the following steps should be performed in order to isolate the cause of the problem. 1. Check the battery. Replace the battery immediately when the “ ”...