IBM Remote Supervisor Adapter User Manual page 85

v IBM Director over modem
v SNMP over PPP
v E-mail over PPP
Type an IP address or host name if you are using the IBM Director over LAN
method.
9. In the Status field, select Enabled to activate this remote alert recipient.
10. Select Enabled in the Receive critical alerts only field if you want the
recipient to receive only critical alerts.
11. Select the notification method for reaching the recipient in the Notification
Method field. Select from one of the following notification methods:
v Numeric pager
v Alphanumeric pager
v IBM Director over Modem
v IBM Director over LAN
v SNMP over LAN
v E-mail over LAN
v SNMP over PPP
v E-mail over PPP
Notes:
a. To configure a remote alert recipient for IBM Director over Modem or IBM
Director over LAN, the remote alert recipient must be a server with the
Director Management Server installed.
b. The IBM Director over Modem option is supported in only IBM Director
versions 2.2.1, 3.1, and 3.1.1.
12. If you selected alphanumeric pager as the notification method, enter the PIN in
the PIN field (alphanumeric pager only).
13. If you select the E-mail over PPP or SNMP over PPP notification method, type
the login ID needed to log in to the dial-up service account of the recipient at
the PPP Login ID field. The PPP login ID consists of a secure IP address, an
account name, and a user ID all separated by periods.
For example, to log in to the IBM Global Network IP Remote Access Service
Provider, the PPP login ID should contain information in the following format:
secureip.X.Y, where secureip is your service, X is your account name, and Y is
your user ID.
Note: For the SNMP over LAN and SNMP over PPP notification methods to
work properly, configure the SNMP options on the Network
Interfaces/Protocols window. For information about SNMP, see
"Configuring SNMP" on page 38.
14. If you select the E-mail over PPP or SNMP over PPP notification method, type
the password that accompanies the login ID in the PPP Password field. Enter
the password needed to login to the dial-up service account. You must fill in
this field for the E-mail over PPP and SNMP over PPP notification methods.
15. If you select the E-mail over LAN or E-mail over PPP notification method, type
the e-mail address for the recipient in the E-mail Address field.
Chapter 7. Configuring your Remote Supervisor Adapter using a text-based interface
79