Table of Contents
Advertisement
10. In the Dialback number field, type the phone number that the Remote
11. Click Save to save your login ID settings.
Setting the global login settings
Complete the following steps to enable your modem to dial out to the remote login
profile:
1. Log in to the Remote Supervisor Adapter for which you want to set the global
2. For an xSeries 330 server: If you want to set the modem and dial-in settings
3. In the navigation pane, click Login Profiles.
4. Scroll down to the Global Login Settings section.
6. In the Authority level field, select either Read Only or Read/Write to set the
access rights for this login ID.
Read Only
The user can use the Read Only option to view a window, but not to
make changes. Additionally, users who log in with read-only IDs are
unable to perform file transfers, power and restart actions, or remote
control functions.
Read/Write
The user can use the Read/Write option to take all available actions
provided by the interface, including setting up a user ID and turning off
the server.
7. In the Password field, assign a password to the Login ID.
Valid passwords must contain at least five characters, one of which must be a
nonalphabetic character. Null or empty passwords are accepted.
Note: This password is used with the login ID to grant remote access to the
Remote Supervisor Adapter or ASM processor.
8. In the Confirm Password field, type the password again.
9. In the Dialback status field, select Enabled or Disabled to configure the
Remote Supervisor Adapter or ASM processor to automatically terminate a
successful dial-in attempt and then immediately dial out to a specified number.
If you select Disabled, click Save to save your login ID settings.
Note: If the Dialback status field is set to Enabled, you must enter a phone
number in the Dialback number field of this profile.
Supervisor Adapter will use when dialing back to reach the login ID. This
phone number is dialed when this user successfully logs in to the Remote
Supervisor Adapter.
Note: By default, the Remote Supervisor Adapter and ASM processor are
each configured with one login profile that enables remote access using
a login user ID of USERID and a password of PASSW0RD (the 0 is a
zero). To avoid a potential security exposure, change this default login
profile during the initial setup of the Remote Supervisor Adapter or ASM
processor.
login settings. For more information, see Chapter 2, "Opening and using the
ASM Web interface" on page 3.
on the ASM processor, log in to the ASM processor. For more information, see
"Logging in to the ASM processor in an xSeries 330 server" on page 6.
Chapter 3. Configuring your Remote Supervisor Adapter or ASM processor
21
Advertisement
Table of Contents
