Setting Modem And Dial-In Settings - IBM Remote Supervisor Adapter User Manual

10. In the Status field of the Dial Back Settings option, select Enabled to
11. In the Number field, type the phone number the Remote Supervisor Adapter
12. Press F4 or press Enter to apply your changes.
13. If you want to configure another login profile, press F3 twice to return to the

Setting modem and dial-in settings

Complete the following steps to enable your modem to dial out to the remote login
profile:
1. Log in to the Remote Supervisor Adapter. For more information, see "Accessing
2. For an xSeries 330 server: To set modem and dial-in settings on the ASM
3. In the Advanced System Management window, select Settings. The Settings
4. Select Login & Alert Profiles.
76
Remote Supervisor Adapter: User's Guide
Read-Only
Enables the user to view a window but not to make changes.
Additionally, users who log in with read-only IDs are unable to perform
file transfers, power and restart actions, or remote control functions.
Read/Write
Enables the user to take all available actions provided by the interface,
including setting up a user ID and turning off the server.
configure the Remote Supervisor Adapter to automatically terminate a
successful dial-in attempt, and then immediately dial-out to a specified number.
If you select Disabled in the Status field, you are finished with this procedure.
Note: If the Status field is set to Enabled, you must enter a phone number in
the Number field of this profile.
will use when dialing back. This phone number is dialed when the user profile
successfully logs in to the Remote Supervisor Adapter.
Note: By default, the Remote Supervisor Adapter is configured with one login
profile that enables remote access using a login user ID of USERID and a
password of PASSW0RD (the 0 is a zero). To avoid a potential security
exposure, change this default login profile during the initial setup of the
Remote Supervisor Adapter.
Login & Alert Profiles window.
the text-based interface through a Telnet connection" on page 65 or "Accessing
the text-based interface through a direct serial connection" on page 66.
processor, log in to the ASM processor. For more information, see "Accessing
remote adapters through an ASM interconnect network" on page 67.
window opens.