Charging & Assembly - Capin Billy's Whiz Bang Owner's Manual

Proper assembly, folding and unfolding of the scooter are essential. Always fold and unfold your scooter on a level, stable surface,
in an area which allows you plenty of room to work.
Your new scooter MUST
carefully and follow them fully. Always charge your electric scooter indoors in a well-ventilated area.The charging area should
be non-flammable, dry, level, with good ventilation, and in an area that cannot be reached by children or animals. Do not place
the scooter and Charging Transformer in direct sunlight, near a heat source (water heater, furnace, fireplace, etc.), or in contact
with moisture while charging.
1. Remove your electric scooter from the shipping carton.
2. Place your electric scooter on a level, dry surface and fold the kickstand down.
PRIOR TO CHARGING
• Make sure the power cord, charging cable and charging port are in good condition.
• Do not plug the supplied transformer into AC outlets with multiple sockets while other power cords are plugged in.
• Verify that your Charging Transformer is designed for the voltage in your country.
• We highly recommend that you use only GFCI outlets, or use an adapter to convert standard outlets to GFCI.
These inexpensive adapters are available at most hardware stores.
• If you notice a strange smell, vapors or smoke coming from the Charging Transformer or Batteries, unplug the
Charging Transformer cord immediately! Take your scooter and transformer to your Dealer for service.
PAGE 6
be fully charged before its first use and after each successive use. Please read the instructions
3. Charging & Assembly