Capin Billy's Whiz Bang Owner's Manual page 13

WARNING: Riding with an improperly tightened handlebar or stem can allow the handlebar to turn
or move and cause you to lose control and fall.
THEREFORE:
1. Before you ride the scooter, check that the handlebar and stem are securely clamped.
2. Understand and apply the correct technique for clamping your Height Adjust Quick Release.
Otherwise, ask your Dealer or contact EWI at 1-408-270-3724 or service@electricwheelsintl.com.
USING THE HEIGHT ADJUST QUICK RELEASE MECHANISM
The action of the Quick Release cam squeezes a collar to hold the stem securely in place.The tension-adjusting nut controls
the amount of clamping force.Turning the tension-adjusting nut clockwise, while keeping the cam lever from rotating, increases
clamping force; turning it counterclockwise while keeping the cam lever from rotating reduces clamping force. Less than half
a turn of the tension-adjusting nut can make the difference between safe and unsafe clamping force.
WARNING:The full force of the cam action is needed to clamp the stem securely.You can not
clamp the stem safely by holding the nut with one hand and turning the lever like a wing nut
with the other hand until everything is as tight as you can get it.
WARNING: If you can fully close the Quick Release without wrapping your fingers around the
stem extension tube for leverage, and the lever does not leave a clear imprint in the palm of your
hand, the tension is insufficient. Open the lever; turn the tension-adjusting nut clockwise a quarter
turn; then try again.
PAGE 11