Table of Contents
Advertisement
9. Install the Rear Brake Mount Screw. (Figure 8-H)
10. Slide the motor forward by placing a flat blade
screwdriver into the Belt Adjustment Slot. Pull the
screwdriver towards the rear tire. The belt should
be tight with +/-1/8" play. While holding the belt in
tension, secure the 4 Motor Mount Bolts.
(Figure 8-F & Figure 8-J).
11. Replace the rear wheel covers by pressing the
mount tabs into the tab slots in the rear dropouts.
(Figure 8-G)
12. Test Rear Brake functionality before riding scooter.
TIRE AND/OR TUBE REPLACEMENT
To replace the tire or tube, follow
steps 1 through 6 above, then:
1. Remove the Rear Brake Retainer Nut with a 17mm
box wrench.
2. Holding brake housing, unthread wheel from brake.
3. Replace tire and/or tube with the same size and
specification parts.
4. Reattach the rear brake housing to the rear wheel.
5. Replace the Rear Brake Retainer Nut. See Torque Specifications, Section 11, "Specifications."
6. Assemble the rear wheel assembly following steps 7 through 12 above.
F . TIRES AND TUBES
Your scooter has been equipped with tires that the scooter's manufacturer believes are the best balance of performance and value
for the use for which the scooter is intended. If a tire needs replacing for any reason, contact your Dealer or EWI for a genuine
replacement tire, at 1-408-270-3724 or service@electricwheelsintl.com. In the USA, you may call toll-free 1-888-808-4382.
PAGE 30
Figure 8-H
Figure 8-I
Advertisement
Table of Contents
