Capin Billy's Whiz Bang Owner's Manual page 36

D. BATTERY REPLACEMENT
To replace the batteries, unscrew the Deck Lid D-Ring Fastener located on top of the deck lid by turning it counterclockwise until
the fastener becomes disengaged from the Deck. Pull the D-Ring up and the Lid towards the rear of the scooter.This will disengage
the Lid from the Indexing Slot in the Deck.To reinstall the Lid, reverse the process. Make sure that the Lid is positioned securely
into the Indexing Slot and that the D-Ring is screwed down tightly.
See the complete instructions supplied with your Genuine ETC Replacement Batteries.
ALWAYS RECYCLE OR DISPOSE OF BATTERIES PROPERLY.
Warning: Batteries have Explosive gases – keep away from heat, flames and sparks.
Provide adequate ventilation during charging.
• To extend the life of your batteries, fully charge after each use.
• Always insert the charging plug of the Charging Transformer into the charging socket (located on the left side
of the scooter deck)
a grounded outlet only.
• Recharge the batteries only with the Charging Transformer supplied.
• If you replace the batteries, be sure that the new replacements are ETC Genuine Replacement Batteries ONLY.
• If the Scooter is to be disposed of, please remove and recycle the batteries.
PAGE 34
BEFORE connecting the Transformer to the supply power source. Plug the Transformer into