Capin Billy's Whiz Bang Owner's Manual page 33

A Scooter Tire Pump is supplied
to inflate a scooter tire to the correct pressure
is with the scooter tire pump supplied with
your scooter.
For the best performance, set tire pressure at
or near the maximum recommended pressure
indicated on the tire sidewall.
The valve is just like the valve on a car tire.To inflate
the tire, remove the valve cap and push the air hose
or pump fitting onto the end of the valve stem.To let
air out of a valve, press the pin in the end of the valve
stem with the end of a key or other appropriate object.
CAUTION: Never inflate a tire beyond the maximum pressure marked on the tire's sidewall.
Exceeding the maximum recommended pressure may blow the tire off the rim, which could cause
damage to the scooter and injury to the rider and bystanders.
CAUTION: Gas station air hoses move a large volume of air very rapidly and will raise the pressure
in your tire very rapidly.To avoid over-inflation when using a gas station air hose, put air into your
tire in short, spaced bursts.
CAUTION: Riding your scooter with a flat or under inflated tire can seriously damage the tire,
tube and scooter, and cause you to lose control and fall.
CAUTION: Gas station air hose pressure gauges are often inaccurate and should not be depended
on for consistent, accurate pressure. Instead, use a good quality pencil or dial gauge.
– The best way
Motor Drive Pulley
Figure 8-J
PAGE 31