Cloning Procedures; Cloning Overview; Learning / Teaching A Master Tv Setup Using A Tlx File - LG Centric X950 Series Commercial Mode S Setyp Manual

Cloning Overview

Cloning refers to the process of capturing a Master TV Setup and transferring it to a Target TV that
is to remain in Pass-through Mode. There are two different procedures for cloning a Master TV
Setup, each with its own advantages and limitations (see also "Cloning Methods" on page 32):
• Using a USB memory device / TLX file
• Using a USB memory device / TLL file
Each cloning method is described in further detail on the pages that follow.

Learning / Teaching a Master TV Setup using a TLX File

This section describes how to Learn and/or Teach a Master TV Setup using a TLX file.
Before You Begin
• Ensure the USB device has been formatted with FAT format.
• Learning and Teaching is only possible between identical model TVs.
• Complete the Custom Master TV Setup procedure (see pages 32 to 35).
• If you would like the Target TV(s) to remain in Pass-through Mode after Teaching, ensure the
Master TV does not have an auto-tuned/edited channel lineup; otherwise, Teaching will result in
the Target TV(s) being configured for FTG Mode.
• If a TV Zone # and/or a Wi-Fi Zone # has/have been set in the Master TV (for location-specific
configuration) before the Learning process is initiated, the Zone designation(s) will be used during
the subsequent Teaching process(es). This means that in order for the "Learned" clone data with
TV Zone and/or Wi-Fi Zone assignments to be applied, any Target TVs will need to be assigned
the same Zone designation(s) BEFORE Teaching is performed. See Reference section, "Using
the TV's Zoning Features," for further information. See also bullet below.
• If you intend to use the Zoning feature(s) on this TV, make sure to assign the appropriate TV
Zone # and/or Wi-Fi Zoning # as described in Reference section, "Using the TV's Zoning
Features," BEFORE continuing with the Learning procedure below. See also bullet above. For
the Wi-Fi Zoning feature, the Master TV's wireless network connection settings also should be
configured in the IP Environment Menu before Learning is initiated.
• It is not possible to clone a Master TV's clock. Either set a Target TV's clock manually, or use
the Auto Clock setting in the TV setup menus.
Caution: Do not unplug the TV power cord or remove/disconnect the USB memory
device while Learning or Teaching, as doing so may cause the TV to malfunction or
harm the USB device, respectively.
206-4263

Cloning Procedures

37