LG Centric X950 Series Commercial Mode S Setyp Manual page 35

(Continued from previous page)
5. (PTC cloning only) Transfer the auto-tuned/edited channel lineup (if applicable) and TV
setup menu settings to the PTC: 2-5-5 + MENU Mode
Note: This step is essential for successful cloning using a TLL file. Without this
step, the PTC will not contain any channels or TV setup menu settings.
Note: The maximum number of channels (analog, digital, and Aux inputs) that can
be transferred to the PTC is 141. An attempt to transfer more than 141 channels of
any combination will result in a PTC Channel Map of exactly 141 channels; any extra
channels will not be available in the PTC Channel Map. For example, if you enabled
three Aux inputs in the Installer Menu and Auto Tuning found 141 channels, you must
edit the TV channel lineup to decrease the number of analog/digital channels to (at
most) 138 in order to accommodate the Aux inputs in the PTC Channel Map.
a) After the TV channel lineup has been edited and channel label icons added, tune to the
channel (source) for which you wish to transfer TV setup menu settings.
b) Access the Installer Menu, and press 2-5-5 + MENU SETTINGS on the Installer Remote to
initiate the transfer of the Master TV Setup to the PTC. The TV exits the Installer Menu and
then tunes through the channels in the channel lineup during the transfer. When the transfer
is complete, the TV tunes back to the channel that was tuned before the transfer began.
6. (PTC cloning only / Optional) Add Custom Channel and Aux
Input Labels: 2-5-4 + MENU Mode
2-5-4 + MENU Mode enables you to add/edit channel icons and
custom text labels in the PTC Channel Map once the Master TV Setup
has been transferred as described in the previous step.
Access the Installer Menu, and press 2-5-4 + MENU SETTINGS on the
Installer Remote. Add/edit custom text labels and/or change icons for
the Channel-Time on-screen displays (see 2-5-4 + MENU procedural
information on page 36). Note that broadcast digital channels often
already have a broadcaster generated label. When you are finished,
press MENU SETTINGS to exit 2-5-4 + MENU Mode.
7. Verify the TV setup.
Make sure the TV features are set per your requirements. Also, if
cloning an auto-tuned/edited channel lineup, verify that the channel
lineup, channel icons, and custom text labels (as applicable) are
correct.
8. (Recommended) Lock the channel lineup.
Access the Installer Menu. Set item 028 CH. OVERIDE to 000 and
press OK to lock the channel lineup and restrict access to the TV
setup menus. This step prevents end users from accessing channel
settings (i.e., the Channel Menu will be inaccessible/grayed out). Press
OK again to save your changes and exit the Installer Menu.
The Master TV Setup is now ready to be saved to a USB memory device
(TLX or TLL file). See "Cloning Procedures" on pages 37 to 41.
206-4263
Custom Master TV Setup (Cont.)
Custom text label "WXYZ" created
028
After verifying the TV Setup, it is
recommended that you set Installer
Menu item 028 CH. OVERIDE to 0.
DIGITAL 19-3
MONO STEREO SAP
WXYZ
in 2-5-4 + MENU Mode.
CH. OVERIDE 000
35