IBM eServer xSeries 226 Type 8648 Option Installation Manual page 25

4. Grasp the end of the airlow guide near the front of the server and rotate it out of
the server.
To completely remove the microprocessor air baffle, gently press the sides of the
baffle at the chassis toward each other until the tabs at the rear of the baffle are
free of the slots in the chassis. To replace the air baffle, gently press the sides of
the baffle toward each other until you can insert the rear tabs into the slots in the
rear of the chassis.
Complete the following steps to close the air baffle:
1. Rotate the air baffle to the closed position, carefully guiding the top side of the
air baffle between the cables, so that the cables cross in the notch of the air
baffle side and are not pinched by the baffle.
2. Press the air baffle into place.
Chapter 2. Installing options
13