Care And Cleaning - Sharp R-90GC Operation Manual

R-90GC(S) O/M

CARE AND CLEANING

Disconnect the power supply cord before cleaning or leave the door open to inactivate the oven.
Before cleaning ensure oven cavity is cool.
CLEAN THE OVEN AT REGULAR INTERVALS - Keep the oven clean, or it could lead to deterioration of the
surface. This could adversely affect the life of the appliance and possibly result in a hazardous situation.
Exterior:
The outside may be cleaned with mild soap and warm water, wipe clean with a damp cloth. Avoid the use of
harsh abrasive cleaners.
Door:
Wipe the door and window on both sides, the door seals and adjacent parts frequently with a damp cloth to
remove any spills or splatters. Do not use abrasive cleaners.
Touch Control Panel:
Wipe the panel with a cloth dampened slightly with water only.
Do not scrub or use any sort of chemical cleaners. Avoid the use of excess water.
Interior walls:
Wipe splatters and spills with a little dish washing liquid on a soft damp cloth for hygienic reasons. Use a mild
stainless steel cleaner applied with a soft damp cloth, for stubborn stains inside the oven cavity ONLY. Do not
apply to the inside of the door. Wipe clean ensuring all cleaner is removed.
After use wipe the waveguide cover in the oven with a soft damp cloth to remove any food splashes. Built-up
splashes may overheat and begin to smoke or catch fire. Do not remove the waveguide cover.
DO NOT USE CAUSTIC CLEANERS, ABRASIVE OR HARSH CLEANSERS OR SCOURING PADS ON
YOUR OVEN. NEVER SPRAY OVEN CLEANERS DIRECTLY ONTO ANY PART OF YOUR OVEN.
DO NOT USE A STEAM CLEANER. Avoid using excess water. After cleaning the oven, ensure any water
is remove with a soft cloth.
To assist with cleaning the oven interior, use the Refresh Cycle. (Refer to page 19).
Turntable/Turntable Support/Racks:
Wash with mild soapy water and dry thoroughly.
Note:
Keep the waveguide cover and accessories clean at all times. If you leave grease or fat in the cavity or
accessories, it may overheat, cause arcing,smoke or even catch fire when next using the oven.
SPECIAL NOTE for TURNTABLE SUPPORT:
After cooking, always clean the turntable support, especially around the
rollers. These must be free from food splashes and grease. Built-up
splashes or grease may overheat and cause arcing, which may produce
smoke or catch fire.
R-90GC(S) O/M,15-24 23
23
03.7.11, 2:15 PM
roller