Python Responder LC Model 991 Installation Manual page 50

Responder lc security and remote start
Hide thumbs Also See for Responder LC Model 991:
Table of Contents

Advertisement

age. If programmed OFF (3) the vehicle cranks for the programmed crank time
(feature 3-3) and does not verify with tach or voltage that the car is running. In
the OFF setting, if the vehicle fails to start, the ignition can stay on for the entire
run duration. When set to Tachometer (4), the unit references the learned tach
signal to disengage the starter. In addition it monitors the RPM and shut down if
the engine RPM is too high or too low.
Note:
The tach wire must be connected and programmed for the manual trans-
mission mode to work.
3-3 Crank Time 0.6 (1)
4.0 (9) SECONDS: If the unit is programmed for no engine checking or voltage
sense, the crank time must be set to the appropriate duration. The default setting
is 0.6 second and the LED flashes once. If a different crank time is desired,
toggle through the higher settings by using the two-chirp settings.
3-4 Run Time 12 (1)
that the system operates the engine until the system "times out". The system may
be shut down using the remote or any of the shutdowns at any time. Using the
Bitwriter®, the run time can be programmed for any duration from 1-60 min-
utes.
3-5 Activation Pulse One (1):
to use 1 or 2 pulses to activate the remote start sequence.
Note:
This setting affects both the input wire and the remote control.
3-6 Turbo Mode: OFF (1)
min (5): In the Off setting the turbo mode does not function. In the On and timed
setting, the remote start can be used as a turbo timer. The car remains running
for the programmed runtime, and the ignition is turned Off.
Note:
For this feature to work the "turbo timer run time" mode needs to be
programmed ON and the tachometer wire on the remote start needs to be con-
nected and programmed.
3-7 Timer Mode Run Time—12min (1)
lects the time in minutes that the system operates the engine until the system
50
0.8 (2) 1.0 (3) 1.2 (4) 1.4 (5) 1.6 (6) 1.8 (7) 2.0 (8)
, 24 (2) 60 (3) MINUTES:
Two activation pulses (2). This allows the system
. On1 min (2), On 3 min (3) On 5 min (4) On 10
Selects the time in minutes
, 3(2), 6 (3), 9 (4) MINUTES:
© 2008 Directed Electronics. All rights reserved.
Se-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents