Python Responder LC Model 991 Installation Manual page 48

tional dome light supervision feature must be installed as described in the Wire
Connection Guide. Ignition controlled dome light Off (2).
2-6 FAD w/trunk release On (1): FAD w/trunk release OFF (2). In the default
setting the factory alarm disarm output disarms the factory alarm system any time
the button controlling the trunk release output is pressed.
2-7 Factory Alarm Disarm/With Unlock (1), Before Unlock (2), Remote Start
Only (3):
In the default setting the factory alarm disarm output disarms the factory
alarm system any time the button controlling Unlock or Remote Start is pressed.
The "Before Unlock"(2) output disarms the factory alarm before the unlock
output activates and when remote start is activated. The "Remote Start Only" (3)
disarms the factory alarm only when the remote start is activated.
2-8 FAD 1 pulse (1):
the security system outputs on the Factory alarm disarm wire.
2-9 Aux 1 Validity (1)
(4)
Validity: Output that sends a signal as long as the transmission is re-
ceived.
Latched: Output that sends a signal when the Aux 1 button(s) is pressed
and continues until the same button(s) is pressed again.
Latched, reset with ignition: Similar to the latched output this output type
turns ON the first time the Aux 1 button(s) is pressed and turns OFF the next
the same button is pressed. This output type additionally stops and resets
whenever the ignition is turned ON, and then OFF.
30-second timed: Output that sends a continuous signal for 30 seconds.
Off: Output is disabled.
Note:
All auxiliary channel timed outputs can be programmed using the Bit-
writer® (1-90 seconds)
2-10 Aux 1 Linking, None (1)
(5). When programming to Validity or timed output this can be programmed to
activate when locking or unlocking (or remote start) with the transmitter.
2-11 Aux 2 Validity (1)
48
FAD 2 pulses (2). This setting determines how many pulses
Latched (2), Latch reset w/ignition (3), 30-sec. Timed
Lock (2) Unlock (3) Lock/Unlock (4) Remote Start
Latched (2), Latch reset w/ignition (3), 30-sec. Timed,
© 2008 Directed Electronics. All rights reserved.