Python Responder LC Model 991 Installation Manual page 46

1-9 Comfort Closure Off(1):
dows when the system is locked. If programmed ON, the lock output provides a
20 second pulse when the system is locked. The output is cancelled if the unlock
button is pressed. In the Off setting, the alarm does not perform this function.
(2) Comfort closure 1 - Activates the 20 second timer after the door lock
pulse.
(3) Comfort Closure 2 - Activates the 20 second timer with the door lock
pulse.
To test if the car has the comfort closure:
1. Insert the key into the drivers door key cylinder.
2. Turn the key to the lock position and hold for about 10 seconds.
If Comfort closure is available, the windows (and in some cars the sunroof)
closes.
Note: Some cars require that you turn the key once, release it, and then turn and
hold into the lock position.
Important:
have the capability of closing the windows (and on some
cars the sunroof as well) with the key cylinder in the door.
1-10 HORN FUNCTION FULL ALARM ONLY (1): SIREN FUNCTION - honk
length 20mS (2) 30mS (3) 40mS (4) 50mS (5). Program for output when the
alarm is fully triggered or as the siren (arming/disarming and Warn Away and
full trigger with timing options).
1-11 Hood Trigger (Normally Open) (1):
To program the unit for either a normally open (rests open, or at 12v when the
hood is closed) or a normally closed (rests at ground when the hood is closed)
pin switch.
1-12 Sensor trigger (single) (1) Sensor trigger double (2). When programmed
on; any 2 sensors (zones 2, 4, 7) need to be triggered within 5 seconds of
each other to trigger the alarm. When programmed off; each sensor triggers
the alarm independently.
46
The system can be programmed to close the win-
Comfort closure can only be used on cars that
Hood trigger (normally closed (2).
© 2008 Directed Electronics. All rights reserved.