Table of Contents
Advertisement
SVMASTER -
(When you are finished with the above procedures, the system's siren stops alarming and the parking
lights stop flashing, but the vehicle cannot be started and driven away.)
3. If you use one digit to be a password pin code, skip to Step 6. If you use two digits to be a password pin code,
advance to Step 4.
4. Within 15 seconds of the last digit code enter (the 1st code), turn the Ignition Switch "Off" and then "On".
5. Within 15 seconds, enter your chosen of the second digit code by press and release the Valet Switch.
6. Turn the ignition switch to the "OFF" position. [4] Chirps form siren/horn, [3] flash from parking light to
indicate the system was disarmed.
Note: If someone keys-in the wrong password pin code, the system allows him to make 2 mistakes. If the
third code is still wrong, it will automatically shut down for 5 minutes. During this period the system
will not accept any code and the LED will "pause on" (the LED will turn on 1 second
and turn off 0.1 second).
EXAMPLE: To Override The System With The Password Code 83, you would;
1. Enter the vehicle and turn the ignition switch to 'ON' position. (Alarm will sound.)
2. Within 5 seconds, Press and Release the Valet Switch 8 times
(When finish the above procedure, the system's siren will stop alarming and the parking lights will stop
flashing, but the vehicle cannot be started and driven away.)
3. Within 15 seconds of the last digit code enter (the 1
4. Within 15 seconds, Press and Release the Valet Switch 3 times
5. Turn the Ignition Switch to "Off" position. [4] Chirps form siren/horn and [3] flashes from the parking light
will indicate the system has been disarmed.
I. VALET MODE:
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your
transmitter to a parking attendants or a garage mechanic.
When the system is in valet mode, all alarm function and remote
start functions are bypassed, however the remote panic feature
and remote door locks will remain operational. To use the valet
mode, the system must first be disarmed.
Enter Valet Mode:
1. From the disarmed condition, turn the ignition to the "ON"
position.
2. Push and hold valet switch for 2 seconds until the LED turns on
solid. The LED will remain on as long as the system is in 'valet
mode'.
Exit Valet Mode:
1. To return to normal operation, turn the ignition 'ON'.
2. Push and hold valet switch for 2 seconds. The LED will turn off to
indicate the system has exiting the valet mode.
J. CAR LOCATOR
While the system is armed, press the
siren will chirp 6 times. The parking lights will flash 12 times, for you to easily locate
your vehicle.
K. PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the alarm in case of an emergency.
1. Press and hold the
"Panic" icon will display on the OLED screen.
2. During panic mode, the normal function of this transmitter button will be suspended.
The transmitter
option is installed), however once the
disable device, (where installed) will be enable allowing the vehicle to start.
3. To stop the alarm press the transmitters
4. If the button is not pressed, the alarm will automatically stop after 30 seconds.
L. TRIGGERING THE SYSTEM
When armed, your vehicle is protected as follows:
SVMASTER -
C3RS1000 OP 3/08
(System in Disarm or Valet mode)
button to activate car locator function. The
button for 3 second. The alarm will immediately sound and the
and
buttons can be used to lock and unlock the door (if the
button is pressed, the vehicle's starter
. The panic mode will be turned off immediately.
st
code), turn the Ignition Switch "Off" and then "ON".
16
http://www.msvmaster.lv
-
http://www.msvmaster.lv
-
Advertisement
Table of Contents
