S5100-16P-Ei Ethernet Switch - H3C S5100-SI Series Installation Manual

Installation Manual
H3C S5100-SI/EI Series Ethernet Switches
The lock hole is on the back of the left side panel, as shown in Figure 1-3.
Note:
The lock hole cannot be used when the screw hole above it is in use.
IV. Power supply system
AC input:
Rated voltage range: 100 VAC to 240 VAC, 50 Hz or 60 Hz
Max voltage range: 90 VAC to 264 VAC, 47 Hz to 63 Hz
V. Cooling system
An S5100-8P-EI Ethernet switch provides one fan for heat dissipation.

1.3.2 S5100-16P-EI Ethernet Switch

I. Front panel
An S5100-16P-EI Ethernet switch provides 16 x 10/100/1000Base-T autosensing
Ethernet ports, four 1000Base-X SFP ports, and one console port on the front panel. An
SFP port and its corresponding 10/100/1000Base-T autosensing Ethernet port form a
Combo port. That is, only one of the two ports forming the Combo port can be used at a
time. Table 1-2 shows the mapping relations between the ports forming the Combo port.
Figure 1-12 shows the front panel of an S5100-16P-EI Ethernet switch.
(1): 10/100/1000Base-T autosensing Ethernet port status LEDs
(2): 1000Base-X SFP port status LED
(4): 7-segment digitron display
(6): Ethernet port mode switching LED
Figure 1-12 Front panel of an S5100-16P-EI Ethernet switch
(3): Console port
(5): Power LED
(7): Port status LED mode switch
1-9
Chapter 1 Product Overview