PowerTec MSC1000 Owner's Manual page 13

Figure 22
F
e
n
c
e
Miter Saw Table
• Settings for standard crown molding lying flat on
compound miter saw table.
Figure 23
Inside Corner
IR
IL
NOTE: The chart below references a compound cut for
crown molding
OR
OL
Outside Corner
ONLY WHEN THE ANGLE BETWEEN THE
WALLS EQUALS EXACTLY 90°
BEVEL MITER
KEY
SETTING SETTING
Inside corner-Left side
IL 33.9° 31.6° Right 1. Position top of
Inside corner –Right side
IR 33.9° 31.6°Left
Outside corner-Left side
OL 33.9° 31.6°Left
Outside corner-Right side
OR 33.9° 31.6°Right
TYPE OF CUT
molding against
fence
2. Miter table set at
RIGHT 31.6°
3. LEFT side is
finished piece
1. Position bottom of
molding against
fence
2. Miter table set at
LEFT 31.6
3. LEFT side is
finished piece
1. Position bottom of
molding against
fence
2. Miter table set at
LEFT 31.6
3. RIGHT side is
finished piece
1. Position top of
molding against
fence
2. Miter table set at
RIGHT 31.6
3. RIGHT side is
finished piece
11