Table of Contents
Advertisement
Figure 5
Trigger Switch
4
LOCKING CUTTING HEAD IN DOWN
POSITION
•
Push the switch handle down to the lowest position
•
Pull the hold-down lock out of the short slot. Rotate 90°
to the lock position in the long slot.
INSTALLATION OF DUST BAG
Refer to Figure 6
•
Squeeze the wire located at the end of dust bag.
•
Place the dust bag opening onto the dust port and
release the wire securing the dust bag onto the dust
port.
Figure 6
Dust Bag
Port
INSTALLATION OF THE HOLD-DOWN CLAMP
ASSEMBLY
Refer to Figure 7
•
Loosen the lock knob from the rear side of the saw
base.
•
Place the hold-down clamp assembly in one of the
mounting holes.
•
Tighten the lock knob.
Short slot
Switch handle
Slot
Hold down lock
Wire
Figure 7
Long slot
Hold down clamp
REMOVAL AND INSTALLATION OF THE
BLADE
WARNING
Turn the switch to OFF position and disconnect the
machine from power source.
REMOVING BLADES
Refer to Figure 8, 9 and 10
•
Raise the cutting head to the upright position.
•
Raise the lower blade guard to the up position.
•
Loosen the cover plate screw using a Phillips or straight
screwdriver.
•
Rotate the cover plate counterclockwise so the arbor
bolt is exposed.
•
Press and hold the arbor lock.
•
Use the large hex wrench to remove the arbor bolt by
turning wrench clockwise.
Figure 8
•
Remove the arbor bolt, outer washer and the blade.
Inner washer does not need to be removed.
Mounting holes
Blade guard
Plate screw
Cover plate
Arbor bolt
Advertisement
Table of Contents
