Table of Contents
Advertisement
14
SYMPTON
Cutting arm will not fully raise
or blade guard won't fully
close
Blade binds jams ,burns
wood
Saw vibrates or shakes
The laser guide fails to turn
on
TROUBLESHOOTING
POSSIBLE CAUSE(S)
1. Pivot bolt too tight
2. Pivot spring not replaced properly
after service
3. Sawdust build-up
1. Improper operation
2. Dull or wareped blade
3. Improper blade size
4. Wood is moving during cut
1. Saw blade not round/damaged/
loose
2. Arbor bolt loose
1. The batteries are dead
2. The battery contacts need
adjustment
SOLUTIONS
1. Loosen pivot bolt lock nut
2. Contact Service center
3. Clean and lubricate moving parts
1. See OPERATION section for the proper use.
2. Replace or sharpen blade
3. Replace with 10-in.diameter blade
4. Use hold down clamp to secure workpiece
to table
1. Replace blade
2. Tighten arbor bolt
1. Replace with new AAA batteries
2. Reload the batteries and make certain that
they make solid contact to the battery spring
Advertisement
Table of Contents
