Installing Memory - IBM 2283 User Manual

Installing memory

You can add memory to your computer to increase system performance. Your
computer has two DIMM connectors 1 for installing memory. The maximum
amount of SDRAM memory is 2 GB.
To install a DIMM, do the following:
1. Remove the rear computer cover. See "Removing the rear cover" on page 37.
2. Remove the hard disk drive. See "Removing the hard disk drive" on page 39.
3. Locate the DIMM sockets on the system board. See "System board" on page
35.
4. Open the module retaining clips on one of the DIMM sockets.
Note: If you are replacing an existing DIMM, remove the existing DIMM.
40
User Guide