Electrical Connection - Electrolux EHGC64AS User Manual

Under these conditions the outlet pressure should not
vary from the nominal outlet pressure of 2.60kPa by more
the +0.52kPa.
8. If the regulator appears to not be performing
satisfactorily then check the following points.
• If the outlet pressure is consistently too low then the
inlet pressure may be too low and adjustment of an
upstream regulator may be needed, or an upstream
regulator or valve with insufficient flow capacity may
be present in the gas supply line. If this is suspected
then it may be necessary to repeat the checks whilst
measuring both the inlet and outlet pressure to
determine if the inlet pressure is in the range
2.75 – 7.00kPa.
• Check that the fuel selector has been fitted correctly
as per diagram figure 9. Check that the turret screw is
fully screwed down.
• Check that the regulator has been fitted to the gas
supply line in the correct orientation, the arrow on the
base of the body indicates the director of gas flow.
Once these checks have been completed, if the regulator still
fails to perform in a satisfactory manner it should be replaced.
9. One by one, turn the knobs to minimum and screw
in the bypass screw (accessible when the knob is
removed) until a small stable flame results. Turn the
knob to maximum and then back to minimum to ensure
that the correct minimum flame is maintained.
10. Attach the LPG sticker to the cooker, near the gas supply
inlet. Cover the Natural Gas label that is factory fitted.
Figure 9
Electrical connection (220-240 Volts)
The appliance is supplied with a standard 10 Amp
service cord terminated by a 3-pin plug for connection
to a standard household socket. The electrical supply is
required to power the electronic ignition system.
NOTE! It will be necessary for servicing purposes to
disconnect the electrical power supply. The power
point should therefore be accessible after the appliance
is installed.
Diagram 1 is a schematic of the wiring in the appliance.
WEIGHT of the unit is printed on the appliance
packaging label.
Gas cooktops
Diagram 1
Use of hose assemblies
Ensure that the hose assembly is restrained from accidental
contact with the flue outlet of an underbench oven or any
other hot surface of an adjacent appliance.
Turret cover nut
assembly, fully
screwed down
Turret Cover Nut
assembly, removed
from regulator and
Fuel Selector
disassembled
Fuel Selector
oriented for
Natural Gas
Operation
Fuel Selector
oriented
for LPG
Operation
electrolux e:line gas cooktops electrical connection 11