Using Your Cooktop - Electrolux EHGC64AS User Manual

2 electrolux e:line gas cooktops installation
Installation
• An authorised person must install this appliance and
MUST provide a certificate of compliance.
• Before using the appliance, ensure that all packing
materials are removed from the appliance.
• In order to avoid any potential hazard, the installation
instructions in this booklet, and any labels on the
appliance must be followed.
• Ensure that all specified vents, openings and air spaces
are not blocked.
• Where the appliance is built into a benchtop, the
benchtop material must be capable of withstanding 85°C.
Servicing
• Servicing MUST only be carried out by authorised
personnel.
• To maintain safe operation, it is recommended that the
product be inspected every five years by an authorised
service person.
• If the supply cord is damaged, it must be replaced by an
authorised service person in order to avoid a hazard.
Cleaning
• Always ensure the appliance is turned off
before cleaning.
• This appliance contains aluminium fittings.
Do not use caustic based cleaners.
• Do not use steam cleaners as this may cause moisture
build up on electrical components.
• Always clean the appliance immediately after
any food spillage.
• Do not place burner caps in a dishwasher.

Using your cooktop

Controls
Each burner is controlled by a control knob. The markings on
the control panel indicate which burner the knob controls, and
the setting for that burner (see Figure 3).
Figure 3
NOTE! Gas controls turn anticlockwise from 'OFF' and have
limited movement.
Lighting burners
Electronic ignition: These cooktops are fitted with mains
powered ignition. When the appliance has been connected
and the power is on, depressing any knob will release
sparks to all burners.
caution
• Keep hands clear of burners when lighting.
• If burner does not light within 5 seconds, turn knob
to 'OFF' position, allow gas to disperse, then try
lighting again.
• Burners MUST be operated between 'HIGH' and 'LOW'
settings only.
To light a burner, the knob must be turned to the 'HIGH'
position, then pushed down as far as possible for
approximately 5 seconds. If the flame goes out when the
knob is released simply depress the knob again, this time
holding it down with slightly more force for the same length
of time. The height of the flame can be varied by turning
the control knob toward the 'LOW' position.
In the absence of electrical power, carry out the ignition
directly to the burner with a hand held ignition source.