Leg Leveling System; Top Vent Adapter; Rear Vent Adapter - Quadra-Fire CASTILE-MBK-B Owner's Manual Installation And Operation

Castile-B FS Pellet Stove
B. Leg Leveling System
1. Thread Allen bolts through nuts until fl ush. Figure 19.1.
The Allen bolts and nuts are included in the component
pack inside the stove fi rebox.
2. Slide assembled nuts and bolts into slots on legs with
the nuts on the bottom. Figure 19.2. Use a 5/32 in.
(3.96mm) Allen wrench to adjust legs up and down to
desired level. Figure 19.3
Figure 19.1
Figure 19.3 - Bolt fully extended
C. Top Vent Adapter Installation
3 to 3 inch Top Vent Adapter
3 to 6 inch Top Vent Offset Adapter
Installing the Top Vent Adapter
1. Put a layer of high temperature silicone on the 3 inch
(76mm) rear exhaust outlet.Do not put silicone
inside of pipe. Figure 19.4
2. Slide the top vent adapter onto the rear exhaust outlet
and adjust the assembly to a vertical position. Figure
19.4
3. Drill 4 holes with #26 drill bit (provided) into the back
of the appliance using the outer shield as a pattern
(make sure the assembly is vertical). Figure 19.4
4. Install the 4 mounting screws.
5. Drill 2 holes with #26 drill bit through the rear exhaust
outlet using the 2 holes already in the short horizontal
pipe in the top vent adapter as a guide. Install the 4
screws. Figure 19.5.
6. Install the vent pipe into the top vent adapter (be sure
to silicone all joints).
May 12, 2014
Figure 19.2

Top Vent Adapter

3 to 3 inch
Figure 19.4
Mount with
4 screws
Figure 19.5
D. Rear Vent and Rear Vent to Top Vent
Adapter Installation
Rear Vent
Clean-Out Cover
Figure 19.6
1. Put a layer of high temperature silicone on the 3 inch
(76mm) exhaust outlet. Do not put silicone inside of
pipe. Figure 19.4
2. Slide the adapter onto the rear exhaust outlet and adjust
the assembly to the appropriate position.
3. Install the vent pipe into the adapter (be sure to silicone
all joints)
7021-130F
Offset Collar
Rear Exhaust Outlet
3 to 6 inch
Use hole on each side
as drilling guide
Clean-Out Cover
Rear to Top Vent
Clean-Out Cover
Figure 19.7
Page 19