Section 2; Turn The System On; Daily Operation 15 2. Operating The Redmike Vc - LightSpeed Technologies TOPCAT User Manual

Classroom audio system
Hide thumbs Also See for TOPCAT:
Table of Contents

Advertisement

SECTION 2:

DAIlY
OPERATION

1. TURN THE SYSTEM ON

Press the POWER button on the Media Connector. The blue LED will glow.
NOTE: since the TOPCAT is mounted in the ceiling, the Media Connector is used
to remotely power the system on and off.
14
LINK
REGISTR
POWER
2. OPERATING THE REDMIKE VC
1. Ensure the REDMIKE VC is fully
charged. The charger LED will
glow green.
2. Remove the REDMIKE VC from the
cradle charger and turn it on.
3. Slip the REDMIKE VC with lanyard
around the neck and position the
top of the microphone just below
the collarbone. NOTE: Positioning
of the REDMIKE VC is critical for
proper volume adjustment.
4. Speak using a conversational level
and TOPCAT will evenly distribute
your voice throughout the room.
5. The TOPCAT has been set-up to
provide optimum volume level
during installation.
REMEMBER: This equipment
supplements the user's voice
so they are able to speak in a
conversational tone. Having the
volume set too high will result in
feedback and listener fatigue.
6. To fine-tune the volume, use the
up/down buttons on the back of
the REDMIKE VC.
NOTE: the REDMIKE VC has 4
volume levels up and 4 levels
down from the mid point (9 levels
total).
7. If a second REDMIKE VC was
purchased, repeat these steps.
This microphone will be marked
with a "CH. B" sticker on the back,
indicating it is preset to channel B.
8. To use the REDMIKE VC as
a handheld pass-around
microphone:
a. unclip the lanyard,
b. hold the lower portion of the
microphone,
c. ensure the IR emitter is facing
outward,
d. position the top of the
microphone at about
collarbone height.
15

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TOPCAT and is the answer not in the manual?

Questions and answers

Table of Contents