Testing A Switch For Continuity; Testing A Solenoid For Continuity; Continuity Check Of Switch; Continuity Check Of Solenoid - E-Z-GO TXT 48V Repair And Service Manual

Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions, Dangers and Warnings.
If a power wire (battery, motor or controller) is discon-
nected for any reason on the TCT model vehicle, the
Run-Tow/Maintenance switch must be left in the 'Tow/
Maintenance' position for at least 30 seconds after the
circuit is restored.
Turn the key switch to 'OFF' and place the direction
selector in neutral before disconnecting power by
removing the BL- connection to the battery. Always use
insulated wrenches when working on batteries. To
check for continuity, set the DVOM to the KΩ setting and
select 'Continuity'. The meter will give an audible signal
when it detects continuity. If the meter does not have a
continuity setting, set it to KΩ, the meter will indicate "0"
when it detects continuity.

Testing a Switch for Continuity

Place one probe on one contact of the switch, place the
second probe on the second terminal of the switch (Ref.
Fig. 5 on Page E-5).
Actuating a normally open (NO) switch will cause the
DVOM to show "0" or give an audible indication when
the switch is operated. A normally closed (NC) switch
will cause the meter to show "0" or give an audible indi-
cation when the probes are attached without activating
switch. The audible indicator will stop and the meter dis-
play will indicate a value greater than "0" when the
switch is activated.
The change in display or audible indicator demonstrates
that the switch is functioning.

Testing a Solenoid for Continuity

Place one probe on one of the large terminals and the
other probe on the second large terminal (Ref. Fig. 6 on
Page E-5). If the meter shows "0" or gives an audible
indication, the solenoid terminals are "welded" closed
and the solenoid must be replaced.
ELECTRONIC SPEED CONTROL - TCT
If the continuity test indicates that contacts are not
"welded" and the wiring to the solenoid coil is good, the
coil has failed and the solenoid must be replaced.
Repair and Service Manual
Fig. 5 Continuity Check of Switch
Fig. 6 Continuity Check of Solenoid
Press to
activate
switch
Page E-5