Rear Windshield - E-Z-GO TXT 48V Repair And Service Manual

Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions, Dangers and Warnings.

REAR WINDSHIELD

Remove protective covering from rear windshield (2)
(Ref. Fig. 4 on Page Q-5).
Install sash (3) on each side of rear windshield. Using a
rubber mallet, gently tap sash to ensure rear windshield
seats properly (See Detail A).
Insert screw (4) through washer (5), rubber grommet (6)
and existing hole in rear strut. Secure with washer (5)
and lock nut (7) (See Detail B). Do not over-tighten or
squeeze grommet.
Place bottom section of rear windshield on rubber grom-
mets and press the sash, starting at the bottom, onto the
rear strut so that it snaps into place (See Details B and
C). Repeat for opposite side of rear windshield.
DETAIL B
2
6
5
4
Front of Vehicle
Fig. 4 Rear Windshield
Repair and Service Manual
WEATHER PROTECTION
Windshield
3
DETAIL C
7
5
Windshield
Strut
DETAIL A
3
Strut
3
Page Q-5