Stelpro STE241 User Manual page 10

3. Activate the Smart mode by simultaneously pressing down the two
buttons for at least 3 seconds. The
mode was already activated, the same procedure should be used to
deactivate it.
4. When the adjustment is completed, release the buttons and wait for 5
seconds to exit the adjustment function.
N.B. It is always possible to manually change the Day/Night mode
during a 24-hour cycle. However, any manual return to the Night mode
will re-initialize the Night mode timer to the latest value recorded, which
modifies the cycle in progress. In all cases, at the end of the 24-hour cycle,
the thermostat will return to the Night mode and start a new cycle. It is thus
not necessary to readjust the Smart mode when a manual change is made
to the Day/Night mode.
When turning back on after being powered off (because of a power outage,
for example), the automatization of the Day/Night modes is deactivated,
and, if previously activated, the icon
soon as you press down a button.
Display in degrees celsius/Fahrenheit
The thermostat can display the ambient temperature and the set point in
degrees Celsius (standard factory setting) or Fahrenheit.
Selection procedure for degree Celsius/Fahrenheit display.
1. From the Day mode, simultaneously press down the two buttons for more
than 3 seconds.
2. Press down the top button to switch from the degrees Celsius to the
degrees Fahrenheit, and conversely. The degree Celsius or Fahrenheit
symbol will be displayed.
3. When the adjustment is completed, release the buttons and wait for 5
seconds to exit the adjustment function.
Long cycle/short cycle mode
The Long/Short cycle activation is similar to the Celsius/Fahrenheit degrees
adjustment. To switch from long cycle heating (15 minutes) to a short cycle
heating (15 seconds), you must simultaneously press down both buttons
during 3 seconds in Day mode. After 3 seconds, the C or F icon will blink.
Release the buttons. The screen then displays CC to indicate short cycle or
CL to indicate the long cycle. To switch from one mode to the other, press
down the bottom button. Once the adjustment done, exit this mode by not
pressing down any button for 5 seconds.
icon will appear. If the Smart
will blink. The blinking will stop as
10
INSSTE2410613