Removing The Hub Cover; Removing The Wheel Axle Bearings - PIAGGIO MSS Fly 50 4T Workshop Manual

Engine

Removing the hub cover

- Drain the rear hub oil
- Remove driven pulley
- Remove the rear brake shoes
- Remove the 5 screws fixing the cover to the
crankcase
- Remove the cover with the wheel axle and pull it
out
- Remove the intermediate gear with the appropri-
ate shim washers

Removing the wheel axle bearings

- Remove the oil seal and the seeger ring.
- Fix the hub cover properly to avoid damaging the
sealing surface with the housing
- Remove the wheel axle bearing using the specific
tool
Specific tooling
020363Y 20 mm guide
020376Y Adaptor handle
020477Y Adaptor 37 mm
ENG - 74
MSS Fly 50 4T