Table of Contents
Advertisement
You can specify 8 rules for each direction: inbound or outbound. For each rule, you can
define the following:
•
Source IP address
•
Source port
•
Destination IP address
•
Destination port
•
Protocol: TCP or UDP or both.
•
Use Rule#
For source or destination IP address, you can define a single IP address (4.3.2.1) or a
range of IP addresses (4.3.2.1-4.3.2.254). An empty implies all IP addresses.
For source or destination port, you can define a single port (80) or a range of ports
(1000-1999). Add prefix "T" or "U" to specify TCP or UDP protocol. For example, T80, U53,
U2000-2999, No prefix indicates both TCP and UDP are defined. An empty implies all port
addresses. Packet Filter can work with Scheduling Rules, and give user more flexibility on
Access control. For Detail, please refer to Scheduling Rule.
Each rule can be enabled or disabled individually.
Click on "Save" to store your settings or click "Undo" to give up the changes.
AirLive Air3GII User's Manual
42
3.Installation/Un-installation
Advertisement
Table of Contents
