Clearances; Flue / Chimney - Baxi 910 Installer And Owner Manual

Clearances.

Clearances from combustible and non-combustible materials must be at least those
shown in figure 6.
IMPORTANT: Reducing the clearance distance at the rear of the stove (especially
with non-combustible surfaces) can result in the stove switching off. This occurs when
the thermal switch operates due to insufficient cool air.
Figure 6. Dimensions and Clearances

Flue / Chimney.

The stove is approved for use with 102mm (4 inch) diameter insulated Selkirk
insta - lock gas vent.
The spigot is designed to be compatible with a selkirk 4 SIL - DH draft hood
connector. The inner sleeve will require reducing in length so that it protrudes 25mm
below the outer sleeve (See figure 7).
Before you install the stove make sure the
chimney flue outlet is correctly positioned to align
with the flue outlet on the stove and that the
chimney is in good condition. If not, a chimney liner
must be installed or a suitable class 2 gas flue
used. A draught is necessary to ensure the products
of combustion are fully evacuated. Connect and
seal the stove flue collar to the chimney using full
depth of collar. The flue must have a minimum
effective height of 3 metres (10ft), however to, to
ensure optimum performance we recommend 3.66
©
Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE
Page 12
Figure 7.