Table of Contents
Advertisement
3. Connect the power cord to the monitor and then plug the power cord into a
Switching on your monitor
1. Switch on your computer.
2. Switch on your monitor by pushing and releasing the power switch marked "
3. To update or install device drivers, follow the instructions in the Device driver
4. If you are using the analog connector, run Image setup by following the
10
properly grounded outlet. Next, reconnect the power cords to your computer
and all attached devices.
at the front of the bezel.
To switch off your monitor, push and release the power switch again.
•
installation section on page 11.
instructions in the Automatic Image setup section on page 14.
"
Advertisement
Table of Contents
