Table of Contents
Advertisement
2.4 System Requirement
Standard 10/100BaseT including network cables with RJ-45 connectors
All PCs need to install the TCP/IP network protocol
2.5 Installation Steps
Please follow the steps below to install WSG-500:
Please follow the steps mentioned below to install the hardware of WSG-500:
1. Place the WSG-500 at a best location.
The best location for WSG-500 is usually at the center of your wireless network.
2. Connect WSG-500 to your outbound network device.
Connect one end of the Ethernet cable to the WAN port of WSG-500 on the front panel. Depending
on the type of internet service provided by your ISP, connect the other end of the cable to the
ATU-Router of an ADSL, a cable modem, a switch or a hub. The WAN LED indicator should be ON to
indicate a proper connection.
3. Connect WSG-500 to your network device.
Connect one end of the Ethernet cable to the LAN1 port of WSG-500 on the front panel. Connect
the other end of the cable to a PC for configuring the system. The LAN1 LED indicator should be ON
to indicate a proper connection.
Note:
WSG-500 has two
LAN1(192.168.1.254) and LAN2(192.168.11.254) respectively.
4. There are two ways to supply power over to WSG-500.
(a)
Connect the DC power adapter to the WSG-500 power socket on the front panel.
(b)
WSG-500 is capable of transmitting DC current via its WAN PoE port. Connect an IEEE
802.3af-compliant PSE device, e.g. a PoE-switch, to the WAN port of WSG-500 with the
Ethernet cable.
virtaul zones Private and Public which are mapped to
WSG-500 Wireless Hotspot Gateway ENGLISH
9
User's Manual
Advertisement
Table of Contents
