Table of Contents
Advertisement
Auto Setup for Windows 95, Windows 98, Windows NT, Windows 2000,
Windows Me or Windows XP
If the monitor is in standby
mode (STANDBY ON), it
may automatically turn off while
you are waiting for it to warm up.
The size and diversity of the
dot pattern varies with the
screen resolution.
To set up the monitor automatically in Windows 95, Windows 98,
Windows NT, Windows 2000, Windows Me, or Windows XP, do the following:
1.
Turn on the monitor first; then the computer.
If the message CHECK SIGNAL CABLE is displayed, or if nothing is
displayed, check:
•
that the video interface cable is connected properly.
•
the correct video adapter card is installed.
•
the correct supported display mode is selected for your computer.
2.
Wait approximately 15 minutes, until the monitor warms up.
3.
Drag the icon bar and tool bar, if they are displayed, to the bottom of the
screen.
4.
Insert the User's Guide and Installation CD into the computer CD-
ROM drive.
5.
Check the operating system installed on your computer and follow the
instructions from the table below.
Operating system
Operating System
Windows 95,
Windows 98,
Windows 2000,
Windows NT,
Windows Me or
Windows XP
6.
When the test pattern appears, press the Image Setup (
the bottom of the monitor. This activates the
which will optimize the display settings with the provided test patterns.
The screen will momentarily turn black while auto adjustment proceeds.
7.
When finished, the Auto Adjustment menu disappears and the screen
returns to a normal display.
8.
Press the
key to return to Windows.
E
SC
You have completed the monitor setup for Windows. If you are using the DOS
operating system, go to
installation steps
Step1
Step2
Select
Select
S
R
TART
UN
on page 14.
Auto Setup for DOS
Step3
Type
:\TESTPAT (change
D
the drive letter to match your
CD-ROM drive if it is not drive
D) and press ENTER
) button at
procedure,
A
S
UTO
ETUP
15
Advertisement
Table of Contents
