Auto Setup For Windows 2003, Windows Me Or Windows Xp - IBM T117 User Manual

Auto Setup for Windows 2003, Windows Me,Windows XP or Windows Vista
If the monitor is in power
saving mode, it may
automatically turn off while
you are waiting for it to warm up.
The size and diversity of the dot
pattern varies with the screen
resolution.
To set up the monitor automatically in Windows 2003, Windows Me,
Windows XP or Windows Vista do the following:
1. Turn on the monitor first; then the computer.
If the message Attention No Signal is displayed, or if nothing is
displayed, check:
• That the video interface cable is connected properly.
• The correct video adapter card is installed.
• The correct supported display mode is selected for your computer.
• If the message "Input not supported" is displayed, configure your
computer for 1280 ×1024@60HZ
2. Wait approximately 15 minutes, until the monitor warms up.
3. Drag the icon bar and tool bar, if they are displayed, to the bottom of
the screen.
4. Insert the User's Guide and Installation CD into the computer
CDROM drive.
5. Check the operating system installed on your computer and follow
the instructions from the table below.
Operating system
Operating Step1
System
Windows 2003,
Windows XP,
Window
2000 server
6. When the test pattern appears, press the AUTO button at the bottom
of the monitor. This activates the AUTO SETUP procedure, which will
optimize the display settings with the provided test patterns.
The screen will momentarily turn black while auto adjustment
proceeds.
7. When finished, the Auto Adjustment menu disappears and the
screen returns to a normal display.
8. Press the ESC key to return to Windows.
You have completed the monitor setup for Windows. If you are using
the DOS operating system, go to
installation steps
Step2
Select Select
S R
TART UN
Auto Setup for DOS
Step3
Type
:\TESTPAT
D
(change
the drive letter to
match your
CD-ROM drive if
it is not drive
D) and press
ENTER
on page 13.
14