Windows Nt, Windows Me Or Windows Xp - IBM T541A User Manual

Auto Setup for Windows 3.1, Windows 95, Windows 98, Windows NT
or Windows 2000, Windows Me or Windows XP
If the monitor is in standby
mode (STANDBY ON), it
may automatically turn off while
you are waiting for it to warm up.
The size and diversity of
the dot pattern varies with
the screen resolution.
Position the mouse pointer
at the bottom center of the
A
screen. This allows
UTO
S
to run properly
ETUP
1. Turn on the monitor first; then the PC.
If the message CHECK SIGNAL CABLE is displayed, or if nothing is
displayed check:
• that the video interface cable is connected properly.
• the correct video adapter card is installed.
• the correct supported display mode is selected for your PC.
2. Wait approximately 15 minutes, until the monitor warms up.
3. Drag the icon bar and tool bar, if they are displayed, to the bottom of the
screen.
4. Insert the User's Guide and Installation Files CD into the computer CD-
ROM drive.
5. Check the operating system installed on your PC and follow the
instructions from the table below.
Operating
System
Windows 3.1
P
Windows NT 3.5
M
Windows 95,
Windows 98,
Windows 2000,
Windows NT,
Windows Me or
Windows XP
6. When the test pattern appears, press the OSD Enter button
bottom of the monitor to display the initial OSD menu.
7. Use an Arrow button (
and press the OSD Enter button
8. Using an Arrow button (
OSD Enter button
will optimize the display settings with the provided test pattern.
The screen will dim, blink on and off several times, and you may notice
small changes to the test pattern.
To abort the
A
UTO
Step1 Step2
Open
Select
ROGRAM
F
ILE
ANGER
Select
Select R
S
TART
or ) to select the
to access the function.
or ), select
. This activates the
function, press the
S
ETUP
Step3 Step4
Type
Select
'd:\TESTPAT'
R
UN
(change the
drive letter to
match your
CD-ROM
drive if it is
UN
not drive D)
and press
ENTER
icon
IMAGE LOCK
and press the
AUTOMATIC
procedure, which
A S
UTO ETUP
key.
E
SC
at the
12