Table of Contents
Advertisement
Manual Setup
If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off while
you are waiting for it to warm up.
16
Manual setup is not required when using digital input.
Normally, you can complete the setup procedure using
if your screen image is still distorted after you perform
Installation CD does not run on your system, perform
1.
Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2.
Display the image you most frequently use on the screen then go to
windows shut down mode.
3.
Press the OSD Enter button
the initial OSD menu.
4.
Use the
or
the OSD Enter button
5.
Use the
or
button to select Clock and Phase to adjustment.
(a) "Clock" (pixel frequency) controls the number of pixels scanned
by one horizontal sweep.
If the frequency is not correct, the screen shows vertical stripes
and the picture does not have the correct width.
(b) "Phase" adjust the phase of the pixel clock signal. With a wrong
phase adjustment the picture has horizontal disturbances in
light picture.
6.
Use a select (
save go to up menu then press the Exit (
You have completed monitor setup.
at the bottom of the monitor to display
button to select the Image Setup icon
to access.
or
) button to manually adjust to correct and execute
; however,
A
S
UTO
ETUP
or the
A
S
UTO
ETUP
.
M
S
ANUAL
ETUP
and press
) button to leave OSD menu.
Advertisement
Table of Contents
