Types 8196 And 8197 - IBM THINKCENTER 8128 Hardware Maintenance Manual

4. Reconnect the external cables and power cords to the computer.
5. If you have replaced the system board, you must update (flash) the BIOS. See
6. To update the configuration, see Chapter 5, "IBM Setup Utility program," on
Note: When the power cord is first plugged in, the computer might appear to turn

Types 8196 and 8197

After replacing FRUs, you need to install any removed parts, replace the cover, and
reconnect any cables, including telephone lines and power cords. Also, depending
on the option that is installed, you might need to confirm the updated information
in the IBM Setup Utility program.
To replace the cover and connect cables to the computer:
1. Ensure that all components have been reassembled correctly and that no tools
2. Clear any cables that might impede the replacement of the cover.
3. Position the cover on the chassis so that the guides on the top and bottom of
66
Hardware Maintenance Manual
"Flash update procedures" on page 113.
page 19.
on for a few seconds and then turn off. This is a normal sequence to enable
the computer to initialize.
or loose screws are left inside the computer.
the cover engage the chassis and push the cover to the closed position. Insert
the screws that secure the cover.