IBM THINKCENTER 8128 Hardware Maintenance Manual page 100

94
Hardware Maintenance Manual
POST Error Code
167
No Processor BIOS Update Found
168
Alert on LAN error
17X, 18X
175 Primary Copy of Secure Data is
damaged
176 The System has been tampered with
177
Corrupted Administrator Password
178
179 Boot Integrity Services Segment Error
183
184
Asset Control Antenna not detected
185
Corrupted boot sequence
186 Security Hardware Control Logic Error
187
189
190
System Security: Invalid Remote Change
Requested
191 System Security: IBM Embedded
Security Hardware Reset
193 System Security: IBM Embedded
Security Hardware Removed
194 System Security: Asset ID Antenna has
been Removed
195 System Security: Asset ID Antenna has
been Installed
196 System Tampered Cleared
1XX
Not listed above
FRU/Action
1. Run Setup. Check Stepping level for
the BIOS level needed, then perform
the flash update.
2. Processor
1. Run Setup. Check to see that Ethernet
and Alert on LAN are enabled.
2. System Board
C2 Security
1. Run Setup. See Chapter 5, "IBM Setup
Utility program," on page 19.
2. System Board
1. Covers were removed from the
computer
System Board
System Board
System Board
1. Enter the administrator password
1. Make sure Asset Care and Asset ID are
enabled in the IBM Setup Utility
program.
2. RFID Antenna
3. System Board
Set configuration and reinstall the boot
sequence
System Board
1. Clear Administration password
2. System Board
More than three password attempts were
made to access the computer
System Board
System Board
System Board
System Board
System Board
System Board
System Board