Types 8189, 8190, 8194, 8195, 8415, 8432, And 8433 - IBM THINKCENTER 8128 Hardware Maintenance Manual

Types 8189, 8190, 8194, 8195, 8415, 8432, and 8433

Drive bay information
Any bay that does not have a drive installed has a static shield and bay panel
installed.
The following illustration shows the locations of the drive bays.
The following list describes some of the drives you can install in each bay and
their height requirements:
Bay 1 and Bay 2 - Maximum height: 43.0 mm (1.7 in.)
Bay 3 , Bay 4 , and Bay 5 - Maximum height: 25.8 mm (1.0 in.)
Removing the drive
1. Remove the cover. See "Removing the cover" on page 30.
2. Remove the front bezel by pushing in on the blue plastic tab at the rear of the
3. Disconnect the signal and power cables from the drive being removed.
48
Hardware Maintenance Manual
chassis.
Note: Take note of the location of any cables you disconnect. You might have
to disconnect cables to other drives to gain access to the drive you are
removing.