Erasing A Lost Or Forgotten Password (Clearing Cmos); Flash Update Procedures; Updating (Flashing) Bios From A Diskette Or Cd-Rom; Updating (Flashing) Bios From Your Operating System - IBM THINKCENTER 8128 Hardware Maintenance Manual

Erasing a lost or forgotten password (clearing CMOS)

This section applies to lost or forgotten passwords. For more information about
lost or forgotten passwords, see Access IBM on your desktop.
Note: Some models have a POV daughter card installed on the system board. In
To erase a forgotten password:
10. Replace the cover and connect the power cord. See "Replacing the cover and

Flash update procedures

This section details how to flash (update) the BIOS. Flash updates are available at
http://www.ibm.com/pc/support// on the World Wide Web.

Updating (flashing) BIOS from a diskette or CD-ROM

1. Shut down the operating system and turn off the computer.
2. Insert the flash update diskette or CD-ROM.
3. Turn on the computer. The update begins.

Updating (flashing) BIOS from your operating system

Note: Due to constant improvements being made to the IBM Web site, Web page
1. From your browser, type http://www.ibm.com/pc/support// in the address
2. Locate the Downloadable files for your machine type.
3. Under Select your product, choose your machine type and click Go.
4.
5. Under Download files - BIOS by date, click your machine type.
these models, the password is stored in the EEPROM on the POV card and
cannot be erased. See "Identifying parts on the system board (all machine
types)" on page 38 for the location of the POV card.
1. Turn off the computer and all attached devices.
2. Remove the cover. See "Removing the cover" on page 30.
3. Locate the Clear CMOS/Recovery jumper on the system board. See
"Identifying parts on the system board (all machine types)" on page 38.
4. If necessary, see "Replacing adapters" on page 39 to remove any adapters that
impede access to the Clear CMOS/Recovery jumper.
5. Move the jumper from the standard position (pins 1 and 2) to the
maintenance or configure position (pins 2 and 3).
6. Replace the cover and connect the power cord. See "Replacing the cover and
connecting the cables" on page 63.
7. Restart the computer, leave it on for approximately 10 seconds. Turn off the
computer by holding the power switch for approximately 5 seconds. The
computer will turn off.
8. Repeat steps 2 through 4 on page 113..
9. Move the jumper back to the standard (pins 1 and 2).
connecting the cables" on page 63.
content (including the links referenced in the following procedure) is subject
to change.
field and press Enter.
In Downloadable file by category, click BIOS.
Chapter 8. Additional Service Information
113