Selecting The Print Density (Dip Switch 2-3/2-4) - Epson TM-T88IV Technical Reference Manual

Selecting the Print Density (DIP Switch 2-3/2-4)

Function
Low power consumption mode
Print density (Standard)
Print density (Darker than standard)
Print density (Dark)
• If the print density is set to "Darker than standard" or "Dark" level, printing speed may be
reduced.
• The print density can be set with DIP switches (2-3/2-4) or to the customized value. (See
"Setting the Memory Switches" on page
"Depends on the DIP switch settings." If the customized value is changed, the value set
with the customized value is enabled.
SW 2-3 SW2-4
ON ON
OFF OFF
ON OFF
OFF ON
43.) The initial setting of the customized value is
Chapter 2 Setup
2
41