Dip Switch Tables - Epson TM-H6000III User Manual

DIP Switch Tables

Serial
SW Function
1-1 Data receive error Ignored
1-2 Receive buffer
capacity
1-3 Handshaking
1-4 Data word length
1-5 Parity check
1-6 Parity selection
1-7 Transmission speed (See table below.)
1-8
2-1 Handshaking
(BUSY condition)
2-2 Customer display
connection
2-3 Print density
2-4
2-5 Internal use. Fixed to Off.
2-6
2-7 I/F pin 6 reset
2-8 I/F pin 25 reset
Transmission speed (bps)-bits per second
SW 4800 9600
1-7 ON OFF
1-8 ON ON
vi
ON OFF
Prints "?"
45 bytes 4 KB
XON/XOFF DTR/DSR
7 bits 8 bits
Enabled Disabled
Even Odd
Receive Offline or
buffer full Receive buffer
full
Connected Not connected
See Table A.
Enabled Disabled
Enabled Disabled
19200 38400
ON OFF
OFF OFF
USB/Parallel
SW Function
1-1 Auto line feed
1-2 Receive buffer
capacity
1-3~ Reserved. Fixed to Off.
1-8
2-1 Handshaking
(BUSY condition)
2-2 USB: Customer
display
connection
Parallel: Internal use. Do not change setting. Fixed
to Off.
2-3 Print density
2-4
2-5 Internal use. Fixed to Off.
2-6
2-7 Reserved (for serial interface) Fixed to Off.
2-8 USB: Fixed to Off.
Parallel: I/F pin 31 reset signal. Do not change set-
ting. Fixed to On.
Table A
Print density/low power
1 Print density (Light)
2
3
4 Print density (Dark)
ON OFF
Always Always disabled
enabled
45 bytes 4 KB
Receive Offline or Receive
buffer full buffer full
Connected Not connected
See Table A.
SW 2-3 SW 2-4
ON ON
OFF OFF
ON OFF
OFF ON