Selecting The Print Density (Dip Switches 2-3/2-4); Selecting The Busy Status - Epson TM-T88V Technical Reference Manual

Selecting the Print Density (DIP Switches 2-3/2-4)

Function
Do not set
Print density (standard)
Print density (darker than standard)
Print density (dark)
• If the print density is set to "Darker than standard" or "Dark" level, print speed may be
• The print density can be set with DIP switches (2-3/2-4) or the customized value. (See

Selecting the BUSY Status

With DIP switch 2-1, you can select conditions for invoking a BUSY state as either of the
following:
• When the receive buffer is full
• When the receive buffer is full or the printer is offline
In either case above, the printer enters the BUSY state after power is turned on (including
resetting with the interface) and when a self-test is being run.
Printer BUSY Condition and Status of DIP Switch 2-1
Offline Dur ing th e per iod after power is tur ned on
(including resetting with the interface) to when the
printer is ready to receive data.
During the self-test.
When the cover is open.
During paper feed with the Feed button.
When the printer stops printing due to a paper-end
(when printer has run out of roll paper).
When waiting for the paper Feed button to be
pressed before macro execution.
When an error has occurred.
When the receive buffer becomes full.
62
SW 2-3
ON
OFF
ON
OFF
reduced.
"Setting the Memory Switches (Customized Value)" on page
the customized value is "Depends on the DIP switch settings." If the customized value is
changed, the value set with the customized value is enabled.
Printer status
SW 2-4
ON
OFF
OFF
ON
63.) The default setting of
DIP SW 2-1
ON
BUSY
BUSY
—
—
—
—
—
BUSY
OFF
BUSY
BUSY
BUSY
BUSY
BUSY
BUSY
BUSY
BUSY