Download Print this page

Clifford RSX1.2 Installation Manual page 37

Car security
Hide thumbs Also See for RSX1.2:

Advertisement

r r a a p p i i d d r r e e s s u u m m e e l l o o g g i i c c
The Rapid Resume Logic feature ensures that when the security system is powered back up after power has been
disconnected, the system will resume the same state it was in before power was lost. For example, if power is
disconnected during a full trigger sequence, the system will still be in the full trigger sequence when power is
reconnected to the unit. If power is disconnected while the unit is disarmed, it will still be disarmed when power
is restored.
t t i i m m e e r r m m o o d d e e
By pressing the remote
tion. The remote start can be shut off by the transmitter by pressing the remote start button
other shut down zones or the ignition becomes active the timer mode will cancel.
1.
Press Timer mode buttons.
2.
The vehicle will confirm with 4 parking light flashes.
3.
A 1-second delay will start.
4.
The system will start the car and will run for the specified duration, unless shut down by the remote start button
with the remote start button
5.
The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down wires.
To exit timer mode, turn the ignition switch on any time the engine is running. The parking lights will flash 4 times, indicating timer
mode has been exited.
5.
The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down wires.
© 2004 Directed Electronics, Inc. Vista, CA
and
buttons the parking lights will flash 4 times and then start the vehicle and run for the set dura-
the system will remain in timer mode.
and remain in timer mode, but if any
. If shut down
3 3 7 7

Advertisement

loading