Advertisement
2 2 - - 9 9 2 2 n n d d I I G G N N I I T T I I O O N N / / A A C C C C E E S S S S O O R R Y Y O O U U T T P P U U T T : : This will allow the PINK/WHITE to be used as a 2 nd ignition or an accessory.
2 2 - - 1 1 0 0 A A C C C C E E S S S S O O R R Y Y S S T T A A T T E E D D U U R R I I N N G G W W A A I I T T - - T T O O - - S S T T A A R R T T : : This will allow the programming of the accessory wire during the
wait-to-start period of a diesel motor. When ON the accessory comes on when the wait-to-start output is acti-
vated and stays on, dropping out during crank and returning once the car has started. When OFF the accessory
will activate as a normal accessory.
2 2 - - 1 1 1 1 2 2 n n d d S S T T A A T T U U S S O O U U T T P P U U T T : : This status will activate 10 seconds after the car has started. It is intended to operate
the defogger circuit. The output can be programmed to a latched or a pulsed output. When programmed to the
latched output the status will only stay active for 10 minutes.
2 2 - - 1 1 2 2 A A N N T T I I - - G G R R I I N N D D O O N N / / O O F F F F : : With the anti-grind On (default) the ground-when-armed output will be active during
remote start operation. If accessories such as a voice module or window module are added to the unit, it may be
necessary to program this feature off.
t t a a c c h h l l e e a a r r n n i i n n g g
To learn the tach signal:
1.
Start the vehicle with the key.
DRW-96
2.
Within 5 seconds, press and H H O O L L D D the Valet/Program switch.
3.
The LED will light constant when the tach signal is learned.
4.
Release the Program switch.
© 2004 Directed Electronics, Inc. Vista, CA
3 3 5 5
Advertisement
