Advertisement
t t r r a a n n s s m m i i t t t t e e r r / / r r e e c c e e i i v v e e r r l l e e a a r r n n r r o o u u t t i i n n e e
The system comes with one transmitter that has been taught to the receiver. The receiver can store up to 4 dif-
ferent transmitter codes in memory. Use the following learn routine to add transmitters to the system or to
change button assignments if desired.
The learn routine may be locked if previously programmed using the Bitwriter. If the horn generates one long
honk when attempting to program the unit, the learn routine is locked and must be unlocked using the Bitwriter™
before proceeding.
The Valet/Program switch, plugged into the blue port, is used for programming. There is a basic sequence of steps
to remember whenever programming this unit: Key, Choose, Transmit and Release.
1.
K K e e y y . . Turn the ignition to the ON position.
2.
C C h h o o o o s s e e . . Within 10 seconds, press and release the Program switch the number of times cor-
responding to the desired channel listed below. Once you have selected the channel, press
the switch once more and H H O O L L D D it. The LED will flash and the horn will honk (if connected)
to confirm the selected channel. Do not release the Program switch.
C C H H A A N N N N E E L L N N U U M M B B E E R R
1
2
3
4
5
6
7
8
9
10
11
* * N N O O T T E E : : For Auto Learn Configurations, see Transmitter Configurations section of this guide.
* * * * N N O O T T E E : : If any button from a known transmitter is programmed to Channel 11, all trans-
mitters will be erased from memory and will revert to the default feature settings. This is
useful in cases where the customer's transmitters are lost or stolen.
© 2004 Directed Electronics, Inc. Vista, CA
F F U U N N C C T T I I O O N N
Auto Learn
Arm Panic On/Panic Off
Disarm Panic Off
Silent Mode Channel 2
Remote Start
Channel 4
Short Run/Turbo
Timer Mode
Arm/Disarm/Panic
Panic Only
Delete All Transmitters
W W I I R R E E C C O O L L O O R R
RED/WHITE
VIOLET/BLACK
2 2 7 7
Advertisement
