Carrier 59MN7A Installation, Start-Up, Operating And Service And Maintenance Instructions page 13

Remove plug from
collector box.
DO NOT DISCARD.
Unconverted Factory Trap Configuration
As Viewed in the Horizontal Right Orientation
Attach condensate trap
to collector box with
screw.
Install plug in open
port on collector box.
Horizontal Right Trap Configuration
Fig. 9 - - Horizontal Right Trap Configuration
Align trap over middle and
right-hand port on collector box.
(Appearance May Vary)
13
If alternate vent position
is required, loosen clamp
on inlet of vent elbow.
Remove trap from
collector box.
Slide relief tube in
stand-offs to adjust length.
Vent elbow shown in alternate
orientation. Tighten clamp on
inlet to vent elbow 15 lb.-in.
A11278