MHSC STLDVNS Installation And Operating Instructions Manual page 36

Designer Series Direct Vent Gas Fireplace
electrical Grounding Instructions: This
appliance is equipped with a three-prong
(grounding) plug for your protection against
shock hazard and should be plugged directly
into a properly grounded three-prong
receptacle.
The black and white wires on the aC box
wiring harness are marked 'Blower', 'Light'
and 'aux'. It is important to use the wires
marked 'Blower' or the control will not work
correctly.
BLoTSTSC SIGNaTuRe CoMMaND SINGLe BLoweR
To Junction Box
In Fireplace
Blower (300w Max)
Blower (300w Max)
The BLOTSDVSC Blower Kit requires the SCSACM A/C
Module and the TSFSC remote to install and operate this
kit. Refer to blower instructions for installation.
NoTe: If two (2) blowers are required with the Signature
Command System SCSACM & TSFSC remote, two (2)
BLOTSTSC Kits must be purchased.
36
{
Light WHITE
BLACK
WHITE
BLACK {
BLACK
Optional
WHITE
AUX
Figure 55 -
BLOTSTSC Blower Wiring Diagram
(shown with 2 blower kits)
FP2708
BLOTKSTSC fan wiring
oPTIoNaL FaN BLoweR SySTeM
electrical connections should only be
performed by a qualified licensed electrician.
Main power supply must be turned off before
connecting the fan to the main electrical
power supply or performing service.
GREEN
Connector
Pin To Contro l Box
Control Board
aC Module
FP2708
20302381